I'll have to give Elecraft a call next week. I worked on the phone with NU4I, and we went step-by-step. We mirrored commands between his and mine. Mine would scan memories, but would not scan from freqA to freqB. -
David Wilburn [EMAIL PROTECTED] K4DGW K2 S/N 5982 On Sat, 2007-12-08 at 13:06 -0500, Dan Barker wrote: > The book says: > > "Store this setting in any memory (using the S T O R E switch), but > instead of tapping the switch for the desired memory, hold the > numbered switch (0 -9 ) until you see S C A N on the display." > > It should say: > > "Store this setting in any memory (using the S T O R E switch a HOLD). THEN > RCL (a hold) and a number (tap to recall memory n, hold to scan from A to B > of memory n). > You will see S C A N on the display." > > It is two operations. > > 1. Store the limits (from vfoA to vfoB and other parameters) in a numbered > memory. > > 2. Start a scan (done by a HOLD vs. a TAP). > > If you do what the book says, it will do the HOLD function of whatever > number you were pressing (in my case 1 so I saw TEST and OPER). > > NOTE TO MANUAL MAINTAINERS: Please edit this correction. It's very rough. > Also, I'm quoting Rev F, not G. > > hth > > Dan / WG4S / K2 #2456 > > > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of David Wilburn > Sent: Saturday, December 08, 2007 9:35 AM > To: elecraft > Subject: [Elecraft] K2 and scanning frequencies > > I have read through page 103 of the 'G' manual serveral times now, things do > not seem to be working out. I was hoping to setup two frequencies, either > in memory or with the VFOs, and scan between them. > > I have setup VFOA for freqA and VFOB for freqB, and then held STORE, and > then selected and held a number until SCAN is displayed. If I had two > frequencies in the memory for that same band, it then scanned JUST those to > frequencies. If I did not have any frequencies on that band in memory, it > then 'scanned' the one frequency I put it. > > I then did the same thing, and held down the number key until I got AF ON, > and the same thing happend. > > If I placed the two frequencies in spots 1 and 2, and then did this, it > would scan the frequencies, hopping between them. > > My goal is to scan everything from freqA to freqB and back, continuously. I > must be missing something obvious. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
