G'morning Ian:
No, you don't have to remove the KPA3. You can do gain calibration
procedure at any time. Just set power to exactly 5.0 watts, press tune,
do it on all bands; then set power to 50.0 watts and do the same thing.
73,
Ken K3IU
Ian J Maude wrote:
Hi all,
Can I redo the K3 config on 5W with the PA physically in place or do I
need to remove it? I am no at all happy with the output power so I
want to go through the config again. Like others, I find that on SSB,
the output does not peak at all well.
TX ALC is on but my TXGN HP Pr80 is down at 20, much lower than I have
seen in other reports.
73 Ian
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
