Ian J Maude wrote:
Hi all,
Can I redo the K3 config on 5W with the PA physically in place or do I
need to remove it? I am no at all happy with the output power so I
want to go through the config again. Like others, I find that on SSB,
the output does not peak at all well.
TX ALC is on but my TXGN HP Pr80 is down at 20, much lower than I have
seen in other reports.
OK, this is what I did.
I set KPA3 to 'PAio nor'. I then started at the beginning and did the
Synthesizer calibration, then set the reference oscillator to RWM on
9996 kHz. I then ran the 5W calibration and then, after enabling the PA
again, the 50W calibration.
The output seems much better now but i am going to have to get it on a
decent calibrated wattmeter to be certain of actual output power. TXGN
HP Pr80 is now at 32, in line with other postings.
The question is, how did it change? I had set all of this initially of
course in the build.
In the manual, once you have finished the calibrations, it says to turn
off TECH MD. Could it have something to do with this? I had not turned
it off as I like to see things like PA temp etc and I believe you have
to have it on to see the extended displays.
Sorry if I seem thick, I am just trying to get my head around this.
73 Ian
--
Ian J Maude, G0VGS
SysOp GB7MBC DX Cluster
Member RSGB, GQRP
K2 #4044 |K3 #455
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
