I think if you set CONFIG: KPA3 = PA BYP
and set PWR below 12w that will work.
however, SSB has been greatly improved as of late - ensure you are
running latest firmware and try that first.
--
"There is no limit to what you can accomplish if you don't care who
gets the credit." --Ronald Reagan
On 22 Mar 2008, at 10:02, Ian J Maude wrote:
Hi all,
Can I redo the K3 config on 5W with the PA physically in place or do
I need to remove it? I am no at all happy with the output power so
I want to go through the config again. Like others, I find that on
SSB, the output does not peak at all well.
TX ALC is on but my TXGN HP Pr80 is down at 20, much lower than I
have seen in other reports.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
