Ian J Maude wrote:
>
> Can I redo the K3 config on 5W with the PA physically in place or do I
> need to remove it? I am no at all happy with the output power so I want
> to go through the config again. Like others, I find that on SSB, the
> output does not peak at all well.
> TX ALC is on but my TXGN HP Pr80 is down at 20, much lower than I have
> seen in other reports.
>
You don't need to remove KPA3 for anything unless it's failed. There's a
separate calibration for the 5W and 50W levels on page 46 in the manual, but
they don't interact since the switchpoint between the two amps is 12/13W.
73, Bill
--
View this message in context:
http://www.nabble.com/K3-Configuration-tp16218384p16218430.html
Sent from the Elecraft mailing list archive at Nabble.com.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
