Mike,
Try it using the AUXBUS control before connecting the BAND0-3 outputs
from the ACC connector.
If I recall, the AUXBUS control will also activate the 60 meter KRC2
output when 6 meters is selected on the K3.
Even if my memory is incorrect, it is worth a try, it is an easy matter
to connect the AUXBUS signal from the K3 to the KRC2.
73,
Don W3FPR
AD6XY wrote:
That is a very good idea Joe.
I will try but it will need pull up resistors fitting in the KRC2. Also
because I use transverters I will have to solder 4 more wires and it will
need two multicore cables soldering onto that 15 way din and that is very
difficult because of the size with a connector designed for only one cable.
I will also need to put an ALC line in there once the ALC +- issue is
finalised. I had hoped only to have the K3 linked simply through the KRC2 to
my transverters (like for my K2).
If only the non-atu version of the K3 had two outputs.
Mike
------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - http://www.avg.com
Version: 8.0.169 / Virus Database: 270.6.13/1642 - Release Date: 8/29/2008 6:12 PM
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
