Mike,
For use with the K3 serial port, put in the jumpers for a thru
connection on pins 4 and 6 so any computer application you may want to
use can have access to these K3 serial port pins for PTT and keying.
73,
Don W3FPR
AD6XY wrote:
That might work! Presumably the other features of the KRC2 would not work
without also having the auxbus connected - not a big loss for me. It is
something I will try as it is only going to need a 9-way serial cable with
pins 4 & 6 disconnected via W16 and W20 just in case.
Considering all the other signals on the 15 way connector that I may need
some day, I think perhaps the long term solution will be to construct a
break out board from the 15 way to include a 9 way din for transverters and
KRC2 a connection for the band data, an ALC level converter op-amp and phono
sockets for the other signals (PTT. 2 Digital outputs, PTT, FSK and remote
power on). Point-point or a fairly simple PCB. If I make a PCB I might as
well decode the band data while I am at it.
Mike
------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - http://www.avg.com
Version: 8.0.169 / Virus Database: 270.6.14/1643 - Release Date: 8/30/2008 5:18 PM
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
