Brian, When going to the one digit tuning you are in coarse tuning mode and you should expect that result. Please check you RATE button while in 2-digit tuning. When you tap rate either the 100-Hz digit will flash or the 10-Hz digit. When in the 10- Hz tuning mode it will sound much smoother.
------------------------- 73, Greg - AB7R Whidbey Island WA NA-065 On Tue Sep 2 4:35 , alsopb sent: > >Ran into this interesting problem. Encoder or encoder software? > >K3 2.23/1.88 firmware Don't know about the lastest beta. > >While operating the rig, suddenly tuning across a CW note produced jumps in >frequency rather than a smooth change. The "speed" used was two digits >displayed after the decimal point on the frequency readout. This setting >had never resulted in this "pan pipe" effect before. Switch to "fine' and >back to two digits after the decimal and the problem goes away. > >Doing some digging, here is how it can be produced here. > >1) While in fine mode, press and hold the "fine" button until one digit >appears after the decimal point. >Tune across a signal and one hears the pan pipe effect. >2) Now press fine button until two digits appear after the decimal. >Tune across a signal and the pan pipe effect is still there. > >In all cases going to "fine" with 3 decimal places solves this. If one goes >directly from the three decimal display directly to the the two decimal >display all is always OK. > >It seems like the 1 to 2 digit decimal change doesn't work properly. > >de Brian/K3KO >-- >View this message in context: >http://n2.nabble.com/K3-Encoder-software-problem-- tp833743p833743.html >Sent from the Elecraft mailing list archive at Nabble.com. > >_______________________________________________ >Elecraft mailing list >Post to: [email protected] >You must be a subscriber to post to the list. >Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > >Help: http://mailman.qth.net/subscribers.htm >Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
