How much delay do you need? I use the 50 mS delay from the key out jack, to drive the amp.
Dave Wilburn NM4M eric norris wrote: > Dear Elecrafters: > > I am selling my TS-2000 and building a K3/XV-144 for EME on 2m as well as > normal modes and digital on HF > > My question is, has anyone figured out how to eliminate using a rigblaster > when using a K3 with a sequencer (LNA Technologies)? > > The K3 isolates the > audio signals, but I don't see how I can pick off the PTT without > making it cumbersome to use on HF digital modes (sequencer not used). > Right now I use the LNA Technologies mic cable to pick off the PTT > coming from the rigblaster, send it to the sequencer, then it comes > back to the rig from the sequencer (with the preamp and amp PTT > controlled by the sequencer also). > > This requires using a serial switch--sending the computer signals either to > the K3 (or TS-2000) directly for all other digital modes, but sending it to > the rigblaster when using 2m for EME. > > I would really like to find a solution where I don't have to constantly swap > cables, or cut into the XV-144's PTT line to send it to the sequencer since > this means I would then always have to use the sequencer for 2m. > > Any and all help appreciated. Please reply to my email directly. > > 73, > > Eric WD6DBM > > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
