> "Quick split" - otherwise known as "auto split" or "pileup split" - is > an option that has been available in serious transceivers for almost > twenty years. > > If this option was available and selected, then holding SPLIT would > automate the following sequence which presently has to be done manually: > > 1. Double-tap A>B (reset VFO B, and sub-rx if present, to a known state) > > 2. Hold SPLIT. > > 3. Tune VFO B away from VFO A by a selected amount (+/- in 1kHz steps, > either by pre-selection or 'on the fly' - but the latter would require > extensive error trapping). > > 4. Turn sub-rx on (if it wasn't already on). > > 5. Disable TX on VFO A frequency until SPLIT is canceled (error trapping > for the A/B, REV and A>B buttons).
6. Switch VFO B display to show VFO B frequency if it currently shows some voltage, temperature, decoded text, etc. 73 Val, LZ1VB ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
