Yes, I too had the feeling that this used to work. Stewart G3RXQ On Fri, 19 Jun 2009 22:42:52 -0700, Brett Howard wrote: > I should also state that I swear this was just working a minute ago and > now I seem to always get SUB N/A unless both VFO's are on the same band. > > On Fri, 2009-06-19 at 22:20 -0700, Brett Howard wrote: >> Right now I've got VFO A on 14.030.00 and VFO B on 7.027.00 and I'd like >> to transmit on the VFO B freq. Or I'm trying to setup N1MM so that when >> I click on the VFO B log section that it switches on split so that I can >> TX in the right band. But I keep getting SPL N/A. I even then tapped >> A->B twice and then went back to those frequencies and still got SPL >> N/A. Seems like I'm unable to use the split and TX on VFO B if I'm on >> independant bands? And yes both are set to CW. >> >> Any ideas what I'm doing wrong? >> > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
