You should hear whatever signals the K3 is tuned to. I'm assuming you are connected to the IF OUT jack of the KXV3 or KXV3A.
If you haven't done the IF output mod: http://www.elecraft.com/K3/mods/IF_Output_Buffer_Gain_Mod_Rev_A.pdf then the signal level will be lower than at the K3 antenna connector. But with the K3 preamp on, the difference is small. If you can clearly hear something on the K3, then you should be able to hear it on the K2. Alan N1AL On Tue, 2010-01-12 at 15:05 -0600, [email protected] wrote: > I am trying to verify the output at the IF OUT jack on the back of > the K3. I have it connected to my K2 with the VFO set for 8215.00 and I see > or hear no signal at all. Shouldn't I see the output from the K3? Is the > signal that low that I won't even get a blip on the K2 receiver? Am I > missing something? I see no menu entry for enabling the IF output. HELP > > > Stan Rife > W5EWA ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
