> I'm using the Microham router software to talk to the K3 and this has > been working great until now.
DO NOT use microHAM Router to upload firmware to the K3. It IS NOT SUPPORTED. Find a computer with a hardware serial port or a dumb external USB to serial converter. 73, ... Joe, W4TV > -----Original Message----- > From: [email protected] > [mailto:[email protected]] On Behalf Of W4CCS > Sent: Saturday, February 06, 2010 11:15 AM > To: [email protected] > Subject: [Elecraft] Firmware upload problem > > > Attempted to upload new firmware to the K3 this morning and > got the "MCU > LD" error. Now the K3 is basically dumb. In the manual, it says to > unplug the power for 5 seconds, Hold the power button for > approximately > 10 seconds and then re-load the firmware. > > My problem is that I can no longer get the computer to talk to the K3 > and therefore cannot attempt a re-load. > > I'm using the Microham router software to talk to the K3 and this has > been working great until now. > > Question, does the K3 keep the old settings (38400, 8, N, 1) > or does it > resort back to the default settings which are ?? > > I also tried a direct cable (straight and null modem) and > cannot get any > communication to occur. > > > I'm stuck until I get the K3 talking to the computer again.. > > HELP..!! > > de W4CCS > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
