The K3 bootstrap loader runs at 38400. After firmware loaf, the K3 Utility restores the speed it started with. However if the firmware load fails, the K3 may stay at 38400.
Dick, K6KR Sent from my iPhone On Feb 6, 2010, at 8:14 AM, W4CCS <[email protected]> wrote: > Attempted to upload new firmware to the K3 this morning and got the > "MCU > LD" error. Now the K3 is basically dumb. In the manual, it says to > unplug the power for 5 seconds, Hold the power button for > approximately > 10 seconds and then re-load the firmware. > > My problem is that I can no longer get the computer to talk to the K3 > and therefore cannot attempt a re-load. > > I'm using the Microham router software to talk to the K3 and this has > been working great until now. > > Question, does the K3 keep the old settings (38400, 8, N, 1) or does > it > resort back to the default settings which are ?? > > I also tried a direct cable (straight and null modem) and cannot get > any > communication to occur. > > > I'm stuck until I get the K3 talking to the computer again.. > > HELP..!! > > de W4CCS > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
