Just take the tip of a knife blade and cut a "V" notch through the PC board trace. You do have to apply some pressure to the blade to get into the fiberglass material and through the solder mask. Use whatever knife you are comfortable with, but it should be sharp. I usually use a utility knife or my pocket knife. Do make sure it is sharp, a dull knife can slip when pressure is applied, and we don't want any injuries.
73, Don W3FPR K2QI wrote: > Just saw that Elecraft is now offering a DIY kit to upgrade your current DSP > board with the LPF module. This is a good option as the current exchange > program is taking waaay too long. I was on the list to receive an upgraded > board since early December and still nothing. I finally decided to take > myself off the list, and I think I'll pursue the DIY option instead. > > Anyway, just going over the instructions and I'm curious as to how you guys > that have done this mod have gone about cutting the two traces? Would an > exacto knife work? > > 73 de James K2QI > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
