Thanks, Don. Yes the graphic can get quite narrow and move around when using the controls as you state, but that wasn't my question. ;-)
73, Mike Don Wilhelm wrote: > Mike, > > That truncated pyramid should change as you move the HI/LO CUT or > SHIFT/WIDTH knobs. In other words, it should respond to changes in > the DSP filter controls. Set the K3 to SSB and if the HI/LO > indicators are not illuminated, push one of the two buttons in - then > turn the HI CUT knob counterclockwise. The segments to the right > should drop off as you rotate the knob. > > Then switch to the SHIFT/WIDTH display - rotate the shift knob and the > display should move left to right (no change in width), and rotate the > WIDTH knob to change the width - when you go counterclockwise, it > should go down to 50 Hz and the number of bars will be only two. > > Yes, there is a lot of granularity to that display, but it still give > a good idea of the filter placement within the audio spectrum > > 73, > Don W3FPR > > Mike wrote: >> The truncated pyramid icon that displays a filter's width only has 2 >> sizes, a wide one (11 'segments') for my 2.8 and a narrower (7 >> 'segments') for both the 400 and 250 filters. Is that the way it's >> supposed to be? The wording on the xfil display is getting too small >> for these eyes. >> >> > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html