Jim, Your last post indicated that you were using a SignalLink to drive the K3. The transmit audio level from the Signallink is attenuated for driving a microphone input - if you are using the K3 Line Input, there may not be adequate drive.
The K3 Line Input level expects a level that is available from a normal soundcard Line Out. The SignalLink provides Mic Level output which is a much lower level. Try plugging the Signallink into the rear mic input (set the K3 Mic sel accordingly), and see if you can obtain good transmit audio. If so, then your Signallink audio level must be increased to allow use of the Line Input on the K3. The SignalLink website has some information about increasing the output level. 73, Don W3FPR Jim / W6JHB wrote: > Got the SSB problem fixed - as suspected, it was my fault - I had mis-read > the manual regarding the bias setting for the MH2 Mic. Ooops! > > But, it did NOT resolve the PSK31 issue. I finally got CocoaModem to trip > the PTT on the K3, but still no RF flowing. I'd appreciate hearing from > anyone using CocoaModem and the K3 to do PSK31. Maybe we can go over > settings to see what I've messed up... > > Tnx & 73, Jim / W6JHB > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
