Jim, I am using essentially the same setup. I got a lot of help from Chen (W7AY) the author of CocoaModem.
I also had a problem of no output and it turned out to be that I was using the default jumper settings on the Signalink and you need to boost the output by setting jumper 3 (JP3). Otherwise, the audio level is too low to drive the K3. So, if you have not done that then I suggest you give it a try. From Chen's advice, I have my audio level to about 0.25 volts RMS (I think that is right, I am going from memory)...along with the Signalink TX level of about 1 oclock this gives the recommended 4 (to 5) bars on the K3 ALC bar graph. More then that and you will be overdriving. 73, phil, K7PEH On Jul 10, 2010, at 4:52 PM, Jim / W6JHB wrote: > > Got the SSB problem fixed - as suspected, it was my fault - I had mis-read > the manual regarding the bias setting for the MH2 Mic. Ooops! > > But, it did NOT resolve the PSK31 issue. I finally got CocoaModem to trip > the PTT on the K3, but still no RF flowing. I'd appreciate hearing from > anyone using CocoaModem and the K3 to do PSK31. Maybe we can go over > settings to see what I've messed up... > > Tnx & 73, Jim / W6JHB > -- > View this message in context: > http://elecraft.365791.n2.nabble.com/K3-SSB-Data-No-Output-Need-suggestions-tp5278730p5278907.html > Sent from the Elecraft mailing list archive at Nabble.com. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
