your scenario isnt different than mine except the g38.3 is replaced by the G10l2.
re challenge: Jog-while-paused is; this one isnt all that difficult to do: - task needs massaging to enable jog in this state - capture position on jog-complete pin and finish - interpreter reads position in synch() - done Not much different than a probe as far as motion is concerned except for the jog, detecting the jog-complete pin, and not probing. So not a whole lot of new state or control flow for that matter. I'm aware that manual-while-paused is much more general. I was probing wether we can get a significant part of the use case for minimum effort. -m Am 10.11.2011 um 09:26 schrieb Chris Morley: > >>> >>> Would you be able to manually touch off in this mode? Lots of people want >>> to touch off new tool at tool change for non repeatable tools. >> >> It would be part of the process, when using a remapped M6. The remap >> procedure would look like so (assuming manual toolchange): >> >> G30 (move to TC position) >> Mxxx (enable jog - this code terminates when a, say, 'continue' button is >> pressed) >> g38.3 ... (touchoff tool at tool length switch) >> >> so you cant touchoff *in* this mode, but it leads up to the steps to do it >> >> > > Sorry I meant with out using a probe switch. > jog manually to touchoff (say using a dowel) > then G10 l2, jog away then continue. > > I say you do like a challenge ! > > Chris M > ------------------------------------------------------------------------------ > RSA(R) Conference 2012 > Save $700 by Nov 18 > Register now > http://p.sf.net/sfu/rsa-sfdev2dev1_______________________________________________ > Emc-developers mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-developers ------------------------------------------------------------------------------ RSA(R) Conference 2012 Save $700 by Nov 18 Register now http://p.sf.net/sfu/rsa-sfdev2dev1 _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
