On 05/11/2014 11:01 AM, tuxcnc wrote: > I found the author's blog: > http://blog.f1oat.org/author/f1oat/, and this is probably > his e-mail address: fri...@teaser.fr. Write to him and do > not forget to share with us the information obtained. Regards. Yes, I have done this. So far, no reply.
Meanwhile, I've been tinkering with the Supereyes microscope. I've built an adapter that holds it in an R-8 3/4" end mill holder. First discovery is the camera view is tilted way to the side, and I didn't allow enough room for centering the camera. So, I'll have to bore the thing out some more. I have two rings of 3 adjustment setscrews but they have run the camera body against the wall of the hole. Second discovery is that at a focus distance of about 5 mm, if you blow the LinuxCNC screen up to full size, it is just about good enough for centering without zoom. Jon ------------------------------------------------------------------------------ Is your legacy SCM system holding you back? Join Perforce May 7 to find out: • 3 signs your SCM is hindering your productivity • Requirements for releasing software faster • Expert tips and advice for migrating your SCM now http://p.sf.net/sfu/perforce _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers
