Just some more info on this....On our turning centers we run from line quite a bit and we always have to move up a line from where we actually want to start and we always go back to the line before an M01. Linuxcnc seems to skip the line that you actually start on and I have seen it skip a whole section of program (not sure it's duplicable)
On the mill I have seen the behavior described and it will actually change every tool in the program until it gets to the correct tool even if the correct tool is already in the spindle. Meaning that if I ran tools 1,2 and three and tried to run from line on the section of the program using tool three it will change to tool 1 and then tool 2 until it gets to tool 3. Mill is 2.7.4- Gmoccapy-ATC component Jeff Johnson john...@superiorroll.com Superior Roll & Turning 734-279-1831 -----Original Message----- From: tero.kaarl...@eka-sorvaus.fi [mailto:turo.kaarl...@co.inet.fi] Sent: Thursday, October 20, 2016 12:58 PM To: emc-developers@lists.sourceforge.net Subject: Re: [Emc-developers] Start from line no Hi, Ok so this is related to LinuxCNC. Not Gmoccapy or my self written ATC component. That is good to know. Might there be a work around? PS. this can also be tested in SIM. -- Tero Kaarlela Production Engineer Eka-Sorvaus OY Nivala Finland ----Alkuperäinen viesti---- Lähettäjä : r.stel...@ibstelzer.de Pvm : 20/10/2016 - 19:37 (EEST) Vastaanottaja : tero.kaarl...@eka-sorvaus.fi, emc-developers@lists.sourceforge.net Aihe : Re: [Emc-developers] Start from line no Hi tero, we see the same behavior in version 2.7.4 with axis interface. I thought it was caused by our self written ATC functions. (The machine is a Klingelnberg Micronic PCB router retrofit with a 110 (10x11) rack tool magazine attached to the Y axis) My question: Is there a flag set when the interpreter is in "Start from here" mode. If so, it would be an easy thing to change the ATC program to handle this. cheers, Rainer -- ===================================================== Ingenieurbüro Stelzer Inhaber: Dipl.-Ing. (RWTH) Rainer Stelzer Adresse: Zeppelinstrasse 36 47638 Straelen Mobil: (++49) 0173-5391086 Telefon: (++49) 02834-4250580 Fax: (++49) 02834-4250590 mailto: i...@ibstelzer.de www: http://www.ibstelzer.de Umsatzsteuer- Identifikationsnr: DE249033623 ===================================================== ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers
