Hi, RPM and feeds are ok. We have a program that runs for 2 hours. If we break a tap in final part. We are not going to run the whole program from start and wait for 2 extra hours to get program done. So we have to run from line.
-- Tero Kaarlela Production Engineer Eka-Sorvaus OY Nivala Finland mob +358 40 5906764 http://www.eka-sorvaus.fi Fri, 21 Oct 2016 08:33:33 +0200 Niemand Sonst <nie...@web.de> wrote: > Am 20.10.2016 um 17:39 schrieb andy pugh: > > On 20 October 2016 at 15:54, tero.kaarl...@eka-sorvaus.fi > > <turo.kaarl...@co.inet.fi> wrote: > >> Might this be a bug? If I try to restart a program with tool > >> changes from certain line. Machine goes to tool change position > >> and goes thru(changes) all tools prior the tool needed for that > >> line and after that starts running program from line wanted. I am > >> running 2.8 and machine has ATC. GUI is gmoccapy. > > That's probably better than the alternative of running from line > > with whatever tool happens to be in the spindle. But I don't think > > that it has always done that. > > This might be a Gmoccapy thing. I have the impression that there are > > quite a few features built-in to Gmoccapy that probably really > > belong in the base software. > > > Hallo Andy, > > > you are right, i included some specials in gmoccapy, but the run from > line stuff is a pure linuxcnc base stuff. > > I strongly recommend not to use run from line in linuxcnc, as it does > not take care of every "code" in front of the line you start from. > > In previous versions not even the tool change had been considered, > that is the reason why I diabled by default the run from line in > gmoccapy. > > I have not checked on the recent master, if that has been changed, > does the machine start with correct feed and speed and coolnat option? > > > Norbert > > > ------------------------------------------------------------------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, SlashDot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-developers mailing list > Emc-developers@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-developers -- Tero Kaarlela Production Engineer Eka-Sorvaus OY Nivala Finland mob +358 40 5906764 http://www.eka-sorvaus.fi ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers
