On 08/14/2018 10:03 AM, Frank Tkalcevic wrote: >>> If you don't want a GUI do you want a G-code interpreter, or are you >>> planning on using just HAL? >> HAL, EMCMOT, EMCIO, EMCTASK, NML-SERVER should be on the small board. A >> GUI will work via network. I think that should avoid installation of > Axis can run via standard X-Windows. That's how I do most of my > development. I use Cygwin/X on my Windows 10 computer, ssh to linuxcnc > computer (ssh -Y username@machinename), then just run axis. The axis window > appears on my Windows 10 box. The updates are a little slow though. > > You don't need X-Windows running on the linuxcnc box. This gives back a lot > of RAM. > > Frank That's good. Can we also reduce the amount of depend packages determined by "dpkg-checkbuilddeps"? If we don't need a GUI locally, I think most of them are not necessary. > > > ------------------------------------------------------------------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-developers mailing list > Emc-developers@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-developers
------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers
