I'd say either a comb generator, or a sweep generator but use them to excite a test object of the same general size as the equipment you wish to test. The smaller your chamber, the more it will be affected by the size of an EUT sitting in it. If you can be pretty sure what you will test, add its cables, too.
And no, I'd give the same answer for both. That's my two-cents worth, anyway. Cortland ====================== Original Message Follows ==================== (Headers snipped) What's the best way to correlate a pre-compliance chamber (smaller than a 3m chamber) to a 10m anechoic chamber? Should I use a signal generator and antenna or should I use a comb generator? Would the answer be different if I were correlating the pre-compliance chamber to an OATS? Thanks in advance. Allen Tudor, Compliance Engineer ADC DSL Systems Inc. 6531 Meridien Dr. Raleigh, NC 27616 phone: 919.875.3382 email: [email protected] ------------------------------------------- This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Jim Bacher: [email protected] Michael Garretson: [email protected] For policy questions, send mail to: Richard Nute: [email protected]
