Greetings Cecil and fellow Forumites,

The best summation of test report content I have seen for a long time may be
found at the following link: http://www.conformity.com/0204123s.pdf
<http://www.conformity.com/0204123s.pdf>  
I would invite all to read it, irrespective of discipline.

Regards,

Alan Brewster
Senior Systems Safety Engineer
Novellus Systems, Tualatin, OR
Pager: 888-917-5809
Phone 503-885-6553

        ----------
        From:  [email protected] [SMTP:[email protected]]
        Sent:  Thursday, April 25, 2002 4:18 AM
        To:  [email protected]
        Subject:  EMC test report



        Hi All,

        Does FCC require that all that information be in the final report.
        Such as Product Manufacturer, Table of Contents, Equipment Units
Tested,
        Equipment and Cable Configuration, List of Test Equipment(
calibration
        data), Location of Test Site, Measurement Procedures, Reporting
Measurement
        Data, Summary of Results...
        The reason I ask is that it states that "Digital devices ..are to be
        measured for compliance using the following procedure..." it doesn't
say
        that it needs to be in the final summary.


        Thanks

        Cecil



        -------------------------------------------
        This message is from the IEEE EMC Society Product Safety
        Technical Committee emc-pstc discussion list.

        Visit our web site at:  http://www.ewh.ieee.org/soc/emcs/pstc/

        To cancel your subscription, send mail to:
             [email protected]
        with the single line:
             unsubscribe emc-pstc

        For help, send mail to the list administrators:
             Ron Pickard:              [email protected]
             Dave Heald:               [email protected]

        For policy questions, send mail to:
             Richard Nute:           [email protected]
             Jim Bacher:             [email protected]

        All emc-pstc postings are archived and searchable on the web at:
            http://ieeepstc.mindcruiser.com/
            Click on "browse" and then "emc-pstc mailing list"

-------------------------------------------
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.

Visit our web site at:  http://www.ewh.ieee.org/soc/emcs/pstc/

To cancel your subscription, send mail to:
     [email protected]
with the single line:
     unsubscribe emc-pstc

For help, send mail to the list administrators:
     Ron Pickard:              [email protected]
     Dave Heald:               [email protected]

For policy questions, send mail to:
     Richard Nute:           [email protected]
     Jim Bacher:             [email protected]

All emc-pstc postings are archived and searchable on the web at:
    http://ieeepstc.mindcruiser.com/
    Click on "browse" and then "emc-pstc mailing list"

Reply via email to