From: Douglas Beckwith@MITEL on 02/14/2002 02:06 PM
Hi All,
Thanks for the response. I just want to clarify that this is not our product, it
was prompted by a discussion I had with a someone. So far everyone has supported
my position, that re-test is required and a declaration to EN50082-1 is no
longer valid.
Many thanks to all, I was beginning to doubt my sanity.
Regards
Doug
"Ron Pickard" <[email protected]> on 02/14/2002 12:41:55 PM
To: Douglas Beckwith/Kan/Mitel@Mitel
cc: [email protected]
Subject: Re: Existing EN50082-1 approved products
Doug,
After July 1, 2001, EN50082-1:(1992 or 1997) no longer gives a presumption of
conformity for ITE to
the EMC Directive. This is, of course, assuming your product is ITE, then
EN55024 must indeed apply.
Your declaration of conformity also needs to be updated to reflect this. If your
product is not ITE,
then another immunity standard will likely apply to your product.
I hope this helps.
Best regards,
Ron Pickard
[email protected]
-------------------------------------------
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.
Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/
To cancel your subscription, send mail to:
[email protected]
with the single line:
unsubscribe emc-pstc
For help, send mail to the list administrators:
Ron Pickard: [email protected]
Dave Heald: [email protected]
For policy questions, send mail to:
Richard Nute: [email protected]
Jim Bacher: [email protected]
All emc-pstc postings are archived and searchable on the web at:
http://ieeepstc.mindcruiser.com/
Click on "browse" and then "emc-pstc mailing list"
