Hi Gordon:
> Does anyone know from where the values for creepage and clearances given in
> EN61010-1 ("safety requirements for electrical equipment for measurement,
> control and laboratory use - part 1 general requirements") are derived i.e.
> are there other standards "below" 61010 in this respect?
>From my review of an early version of IEC
61010, the creepage and clearance values
in that early version were derived from IEC
664.
Why are you asking?
Best regards,
Rich
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.
Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/
To cancel your subscription, send mail to:
majord...@ieee.org
with the single line:
unsubscribe emc-pstc
For help, send mail to the list administrators:
Ron Pickard: emc-p...@hypercom.com
Dave Heald: davehe...@attbi.com
For policy questions, send mail to:
Richard Nute: ri...@ieee.org
Jim Bacher: j.bac...@ieee.org
Archive is being moved, we will announce when it is back on-line.
All emc-pstc postings are archived and searchable on the web at:
http://www.ieeecommunities.org/emc-pstc