In message <[email protected]>, dated Sat, 9
Aug 2014, =?iso-8859-2?Q?Bo=B9tjan_Glavi=E8?= <[email protected]>
writes:
Please check clause E.1 in IEC 62368-1. I believe requirements in IEC
60065 are exactly the same. You need to use 1kHz source to verify what
input signal amplitude results in output clipping. Then you need to set
1/8 of maximum non clipped output power with pink noise on input.
Thank you, but I asked specifically about the *definitions* of the two
terms, which I don't think are in the standards you mention. For
example, 60065 uses the term 'non-clipped output power'.
--
OOO - Own Opinions Only. With best wishes. See www.jmwa.demon.co.uk
Quid faciamus nisi sit?
John Woodgate, J M Woodgate and Associates, Rayleigh, Essex UK
-
----------------------------------------------------------------
This message is from the IEEE Product Safety Engineering Society emc-pstc discussion
list. To post a message to the list, send your e-mail to <[email protected]>
All emc-pstc postings are archived and searchable on the web at:
http://www.ieee-pses.org/emc-pstc.html
Attachments are not permitted but the IEEE PSES Online Communities site at
http://product-compliance.oc.ieee.org/ can be used for graphics (in well-used
formats), large files, etc.
Website: http://www.ieee-pses.org/
Instructions: http://www.ieee-pses.org/list.html (including how to unsubscribe)
List rules: http://www.ieee-pses.org/listrules.html
For help, send mail to the list administrators:
Scott Douglas <[email protected]>
Mike Cantwell <[email protected]>
For policy questions, send mail to:
Jim Bacher: <[email protected]>
David Heald: <[email protected]>
