It looks like HAL mist and flood sigs are connected to a couple of the outputs on the AX IO board but it doesn't look like they connect back to iocontrol or halui. This should not be a difficult task. The HAL connections are trivial, even if we add a coolant override switch to the front panel and show off with a ladder rung.
We'd just have to chase down the coolant motor relay puller and connect it to to ax5214h.0.out-16 and make certain we have the correct output module at that location. Then I'd think we'd want to connect the motor overload back into inhibit or at least to an operator message. Rayh On Sun, 18 Nov 2007 15:34:25 -0600, "Enhanced Machine Controller (EMC)" <[email protected]> said: >Dave Engvall wrote: >> Hi Ray et al. >> >> For any kind of production I would think we also need coolant >> going ... and some shielding to keep the coolant in bounds. >> >> Also a fixture. >I think the chip shield pieces on the Mazak are in pretty good >shape. I have no idea how the coolant tank and pump are doing. > >Jon > >------------------------------------------------------------------------- >This SF.net email is sponsored by: Microsoft >Defy all challenges. Microsoft(R) Visual Studio 2005. >http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ >_______________________________________________ >Emc-users mailing list >[email protected] >https://lists.sourceforge.net/lists/listinfo/emc-users > > ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
