On Saturday 09 February 2008 10:58, Jon Elson wrote:
> I notice thay didn't show the cutting tool clearly.  I would 
> have liked to see that.
> Jon

http://www.phorn.de/030610/PDFKataloge/Mehrkantfraeser.pdf
they have an overview of the process at the end  
once the spindle speeds are synchronized you program it just like a turning tool
but they can only take a light cut 

if you look at the tool marks on the flange nuts from your clamping kit they 
were
probably done this way ,the marks will be straight across the flats parallel to 
the flange
with just a hint of the original turned diameter to break the corners

Brian

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to