On Thu, 2008-02-21 at 15:52 -0500, cnc eafit wrote: > Hi there > I just bought a Motenc-lite card that is suposoused to be supported by > linuxcnc. But when I booted the system it does not come up. I'm > totally lost I've been unable to find documentation to fix the > problem. > > > thanks in advance > > > CARD: > MOTENC-Lite 4 axes PCI MOTION & I/O control board > > linuxcnc installed form the lastest cd and updated to 2.2.3 > > lspci > 0000:02:07.0 Bridge: PLX Technology, Inc.: Unknown device 3001 (rev > 01)
I found a small bit of information in the Integrator's Manual on page 131 here: http://www.linuxcnc.org/docs/EMC2_Integrator_Manual.pdf It indicates dmesg might help, after you load the driver with "loadrt hal_motenc" in one of your .hal files. -- Kirk Wallace (California, USA http://www.wallacecompany.com/machine_shop/ Hardinge HNC lathe, Bridgeport mill conversion, doing XY now, Zubal lathe conversion pending) ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
