Hi,
You might try checking the board ID jumpers; it looks like both need
to be in place for board 0.
I don't have a -Lite board but do have the 8 channel board.
Try starting emc with the board not installed and see if you get a
message something like "board not found" or "board not installed".
Usually almost the last thing in the error window.
Then check the jumpers, install the board and go again.
The "Lite" board was used in the Mazak conversion at Fest and worked
quite well. Check the wiki for more information on the conversion.
Good luck.
Dave
On Feb 21, 2008, at 12:52 PM, cnc eafit wrote:
Hi there
I just bought a Motenc-lite card that is suposoused to be supported
by linuxcnc. But when I booted the system it does not come up. I'm
totally lost I've been unable to find documentation to fix the
problem.
thanks in advance
CARD:
MOTENC-Lite 4 axes PCI MOTION & I/O control board
linuxcnc installed form the lastest cd and updated to 2.2.3
lspci
0000:02:07.0 Bridge: PLX Technology, Inc.: Unknown device 3001 (rev
01)
----------------------------------------------------------------------
---
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
