Carl, The Mesa 5i20 with 7i33 and 7i37 work well with the Yaskawa SGDA drives and motors. Tuning is a bit tricky as there is the internal drive-to-motor loop and the EMC2-to-drive loop. I use a 2nd pc running Yaskawa tuning software to tune the drive/motor loop. I have 4 SGDA drives/motors running just sweet with EMC2.
Noel. (Roguish) -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Carl Brown Sent: Thursday, April 03, 2008 3:30 PM To: Enhanced Machine Controller (EMC) Subject: Re: [Emc-users] Router Conversion to EMC2 On Thursday 03 April 2008, Sebastian Kuzminsky wrote: > Check out the wiki, if you haven't already: None of the stuff I have is listed. -- Carl Brown Whitefield, NH USA ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users No virus found in this incoming message. Checked by AVG. Version: 7.5.519 / Virus Database: 269.22.5/1356 - Release Date: 4/2/2008 4:14 PM No virus found in this outgoing message. Checked by AVG. Version: 7.5.519 / Virus Database: 269.22.5/1356 - Release Date: 4/2/2008 4:14 PM ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
