I am very new to this so please bare with me. I did a lot of checking with LEDs
on the parallel port before I actually moved on to a stepping motor driver. But
when I did it all worked and the motor moved as the program I had installed to
test it tld it to. I could tell needed to config it btter so I went through
that program. I used the test this axis button and got it where it was working
really well. so I applyed it. When I went back to my test program nothing
happens. I went back to the config program and again it works fine. (and my
changes were there). What am I missing?
John
-------------------------------------------------------------------------
Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW!
Studies have shown that voting for your favorite open source project,
along with a healthy diet, reduces your potential for chronic lameness
and boredom. Vote Now at http://www.sourceforge.net/community/cca08
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
