A bit more information is needed to help you. Try and be as specific as possible when describing a problem. List each step you took to arrive at your problem.
SWAG, sounds like your test program and the Stepconf config are not the same... John On 11 Jul 2008 at 10:08, Cindee Lichter wrote: > I am very new to this so please bare with me. I did a lot of checking > with LEDs on the parallel port before I actually moved on to a > stepping motor driver. But when I did it all worked and the motor > moved as the program I had installed to test it tld it to. I could > tell needed to config it btter so I went through that program. I used > the test this axis button and got it where it was working really well. > so I applyed it. When I went back to my test program nothing happens. > I went back to the config program and again it works fine. (and my > changes were there). What am I missing? > > John > > > > > ---------------------------------------------------------------------- > --- Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW! > Studies have shown that voting for your favorite open source project, > along with a healthy diet, reduces your potential for chronic lameness > and boredom. Vote Now at http://www.sourceforge.net/community/cca08 > _______________________________________________ Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------- Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW! Studies have shown that voting for your favorite open source project, along with a healthy diet, reduces your potential for chronic lameness and boredom. Vote Now at http://www.sourceforge.net/community/cca08 _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
