On Sat, Jan 31, 2009 at 6:14 PM, John Thornton <[email protected]> wrote:
> Is your Y axis out of square with your X or is it something different? > <http://www.linuxcnc.org/docview/html//config_ini_config.html#sub:%5BAXIS%5D-Section> Exactly - Y out of square. When I run the gantry back against the stops, one side touches before the otherside. I am attempting to machine new parts to correct the problem but I need correction to get reasonably accurate parts. My acme leadscrrews are fine - all are drive and I have not had issues in this arena. The description for doing the compile on the page is nice. It would be usefull to have a link to the EMC-dev install wiki page - searching for that now. THanks for the help. Brian <http://www.linuxcnc.org/docview/html//config_ini_config.html#sub:%5BAXIS%5D-Section> ------------------------------------------------------------------------------ This SF.net email is sponsored by: SourcForge Community SourceForge wants to tell your story. http://p.sf.net/sfu/sf-spreadtheword _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
