It has been a while since I last looked at it but if I remember correctly my 'fix' is just a hack to the tool change routine. on a tool change it takes a note of the current line then stops the interpreter. You can then jog etc. Afterwards it just does a 'run from here'. This only works on a tool change and can't be safely implemented during pause. It is also pretty easy to get things horribly out of sync if you aren't careful. That is why I didn't ask for it to be included in EMC.
Les On 15/05/10 20:19, Dave wrote: > OK.. now I am confused. I haven't looked at Les' jog during tool change > fix. Where is that fix documented? Is it in the Wiki? > > I have no idea why that is not in V2.4. Perhaps no one asked that it be > included? > > Are you saying that you can do a jog during a tool change but you cannot do a > jog during a pause? > > I can clearly see the value of doing a jog during a pause as I have seen > cutters get bound up with stringy swarf many times. > > Dave > ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
