Big misunderstanding on my part here. I thought that Run From Here would re-read and reprocess the entire program up to the point that you wanted to start cutting.
Steve Stallings > -----Original Message----- > From: Slavko Kocjancic [mailto:esla...@gmail.com] > Sent: Monday, May 17, 2010 10:52 AM > To: Enhanced Machine Controller (EMC) > Subject: Re: [Emc-users] Jog under PAUSE / tool cnange > > > > > > Offsets are applied in the interpreter, and the > already-offset motions > > are queued for the motion controller to execute. If you change the > > tool offset, the queue has to be discarded and re-filled with a new > > set of offset motions. Executing G-code can change the > interpreter state, e.g. > > by changing variable values (or coordinate offsets, G90/91 motion > > modes ...). This increases the complexity of re-running > code quite a > > lot, since we would need a way of returning the interpreter to the > > state it was in when the executing motion was queued. > That's not an easy problem. > > > > - Steve > > > > > > > > > There is one (nasty) thing when run from line is applied. > The queue is cleaned and program resume from selected line > but not with correct modal parameters! > > For example: > I run the program and somewhere hit stop. > I do whatever I want and after that resume from selected line. > > Or example 2: > I just finish very long roughting part and decide to turnoff > machine beacouse is time to go to sleep. > In next day just turn on machine select proper point on > program (eg finishing pass) and start from selected line. > ... and got error like F parameter not set or similar "nonsense" > > As run from selected line just do RUN FROM SELECTED LINE! > and if machine is metric and in 1'st line you have G20 then > part come out realy big. > and if somwhere within program some variables are set after > Run from selected line they have big chance to be wrong. > > So be aware from STOP / JOG(go to take beauty sleep) / Run > from selected Line sequence. Can be very unpredictable. > > The solution is that when Run from selected line is executed > the parser run program from start without motion til got > selected line. Of course this is not easy too. Just imagine > probe move here :D > > Slavko. > > -------------------------------------------------------------- > ---------------- > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
