I have noticed that I need a lot more thread depth in G76 than the tables say I should need. For instance an M12 thread should have a thread depth of 1.08mm, but I needed 1.55mm before the nut would fit on. I was using a 29.5 degree "compound slide" angle (Q), do I need to allow for this like you would manually machining? Is it possible that things are getting confused by being in diameter mode? (I have already realised that the first cut is "I" inside the start position, though it took a while)
-- atp ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
