G64 was active to give smoothing between the segments - set in the g-code header script.
Ian On 12/09/2010 19:42, Andy Pugh wrote: > On 12 September 2010 16:52, Ian W. Wright<watchma...@talktalk.net> wrote: >> A couple of days ago I was cutting some ovals. I had the >> feed rate set to 100mm/min but the actual machine speed >> never exceeded 30mm/min because of the short segments. > Could you air-cut the same profile with G64 active and see if it is > any different? > > > > > No virus found in this incoming message. > Checked by AVG - www.avg.com > Version: 9.0.851 / Virus Database: 271.1.1/3130 - Release Date: 09/12/10 > 07:34:00 > ------------------------------------------------------------------------------ Start uncovering the many advantages of virtual appliances and start using them to simplify application deployment and accelerate your shift to cloud computing http://p.sf.net/sfu/novell-sfdev2dev _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
