If it's the motor I've seen on Practical Machinist, the brake is pretty clearly on the shaft end of the motor. This is actually good, you don't want to have to align an encoder. Eric Keller
On Sun, Nov 28, 2010 at 1:08 PM, Tom <[email protected]> wrote: > Ed <ate...@...> writes: > >> On my 10S Red Cap the brake is on the shaft end of the motor. >> >> Can you check the voltage at the leads with the brake connected? If >> there is high resistance it will show full voltage without load and >> droop when connected. Ed. >> > > Ed, > > Yes that is the next step. We are seeing 112vdc on the 2 leads unconnected > and will test for voltage droop when energized and connected next. > > The servo coupler is impossible to disconnect without rotating the > screw to get at the set screws, which can't happen right now - so I am praying > that the brake is located under the encoder, which we can get at. > > These vmcs do not take well to sitting idle... > > Tom > > > > ------------------------------------------------------------------------------ > Increase Visibility of Your 3D Game App & Earn a Chance To Win $500! > Tap into the largest installed PC base & get more eyes on your game by > optimizing for Intel(R) Graphics Technology. Get started today with the > Intel(R) Software Partner Program. Five $500 cash prizes are up for grabs. > http://p.sf.net/sfu/intelisp-dev2dev > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Increase Visibility of Your 3D Game App & Earn a Chance To Win $500! Tap into the largest installed PC base & get more eyes on your game by optimizing for Intel(R) Graphics Technology. Get started today with the Intel(R) Software Partner Program. Five $500 cash prizes are up for grabs. http://p.sf.net/sfu/intelisp-dev2dev _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
