On Fri, 26 Aug 2011, andy pugh wrote:
Date: Fri, 26 Aug 2011 10:53:19 +0100
From: andy pugh <[email protected]>
Reply-To: "Enhanced Machine Controller (EMC)"
<[email protected]>
To: "Enhanced Machine Controller (EMC)" <[email protected]>
Subject: Re: [Emc-users] D510 EPP problem
On 26 August 2011 05:15, Viesturs L??cis <[email protected]> wrote:
And even now dmesg shows:
[ 8.878612] parport0: PC-style at 0x378, irq 7 [PCSPP]
I think you just have to ignore this, the D510 just never admits that
it is in EPP mode, but the EMC2 driver has been modified to carry on
regardless.
I still think it is worth checking that you don't actually have the
small FPGA by accident, that is, after all, the error that is being
reported.
--
atp
"Torque wrenches are for the obedience of fools and the guidance of wise men"
The reason I dont think this is that when debug is on, all thats ever read
from the EPP data port is 0, since all the data bits except bit 0 have strong
pullups in the pre-config case I would expect FE or FF but not 0.
in any case we are geting a D510M0 here to poke around at and compare notes
Peter Wallace
Mesa Electronics
(\__/)
(='.'=) This is Bunny. Copy and paste bunny into your
(")_(") signature to help him gain world domination.
------------------------------------------------------------------------------
EMC VNX: the world's simplest storage, starting under $10K
The only unified storage solution that offers unified management
Up to 160% more powerful than alternatives and 25% more efficient.
Guaranteed. http://p.sf.net/sfu/emc-vnx-dev2dev
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
