Erik, I had similar problems with pncconf using the buildbot 2.5 branch until I updated LinuxCNC using the http://wiki.linuxcnc.org/cgi-bin/wiki.pl?UpdatingTo2.5 instructions. I do not know what is different, it just worked.
Stan > On Wed, 12 Apr 2012, Erik Friesen wrote: > > Date: Thu, 12 Apr 2012 09:06:30 -0400 > From: Erik Friesen <e...@aercon.net> > Subject: Re: [Emc-users] Understanding the 5i25 > To: "Enhanced Machine Controller (EMC)" > <emc-users@lists.sourceforge.net> > Message-ID: > <caeuupiupy6r+aet8k-bgmylf5fdc+r1c2n9byu9n8ncp0rc...@mail.gmail.com> > Content-Type: text/plain; charset=ISO-8859-1 > > After getting started, something seems funny. In the pncconf test window, something is > interfering with proper operation of the stepgen. It runs, but when it decides to stop, I have to > back out of the window, and try again. When I run linuxcnc (2.6.0) when I try to move, it says > joint 0 following error. I am not clear where to head in at here, I don't see anything to do with > encoder setup anywhere. ------------------------------------------------------------------------------ For Developers, A Lot Can Happen In A Second. Boundary is the first to Know...and Tell You. Monitor Your Applications in Ultra-Fine Resolution. Try it FREE! http://p.sf.net/sfu/Boundary-d2dvs2 _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
