Well, I won't say it was unhelpfull.  I pulled it a couple months back, and
added the 5i25.xml I found in another thread.  I wasn't trying to make you
feel bad about it, just clarifying where my trouble points were.  I
understand how much time these things take, so don't be discouraged from my
statements.

Adding a pin inverting option for the stepgen would be handy.

On Fri, Apr 13, 2012 at 2:03 AM, Chris Morley <chrisinnana...@hotmail.com>wrote:

>
>
>
> The pins are not contiguous with their numbers, and are described in the
> 5i25
> manual <http://www.mesanet.com/pdf/parallel/5i25man.pdf> page 9 and 10.
>
> Stepgen_maxaccel must be 20% higher than Max_accel.
>
> pncconf in beta 2.6.0 did not give me a correct setup, probably related to
> max accel and stepgen maxaccel out of sync.
> pncconf confused me, as the pins and numbers didn't seem to line up.
>
> All pins not used by the enabled modules are available for io.
>
>
>
> PNCconf has set the stepgen maxacceleration 25% higher for a very quite
> some time.
> How long ago did you pull beta 2.6.0?
> The numbering system should be by component number rather then connector
> pin number.
> You would need to look in the manual to convert component to connector
> number.
>
> The numbering/tab system is on my todo list to check and hopefully improve.
> The 5i25/sserial cards do pin names/numbering quite different from
> previous cards
> so I am trying to adjust PNCconf to accommodate.
>
> I'm sorry the experience was not helpful.
>
> Chris M
>
>
> ------------------------------------------------------------------------------
> For Developers, A Lot Can Happen In A Second.
> Boundary is the first to Know...and Tell You.
> Monitor Your Applications in Ultra-Fine Resolution. Try it FREE!
> http://p.sf.net/sfu/Boundary-d2dvs2
> _______________________________________________
> Emc-users mailing list
> Emc-users@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/emc-users
>
------------------------------------------------------------------------------
For Developers, A Lot Can Happen In A Second.
Boundary is the first to Know...and Tell You.
Monitor Your Applications in Ultra-Fine Resolution. Try it FREE!
http://p.sf.net/sfu/Boundary-d2dvs2
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to