Jeshua Lacock wrote: > On May 8, 2012, at 8:33 PM, Jon Elson wrote: > > >> How do you know it did not go to >> EPP mode? >> > > I guess I don't know for sure. Your 'univstepdiag' program gives me a > 'Segmentation fault' error and the output from dmesg after attempting to > start LinuxCNC is: > The segfault means that you did not run the diags program with privileges. It must be run with sudo to take control of the parallel port. > [ 8.519908] parport_pc 0000:08:00.0: PCI INT A -> GSI 18 (level, low) -> > IRQ 18 > [ 8.520179] parport0: PC-style at 0xc030 (0xc020), irq 18, using FIFO > [PCSPP,TRISTATE,COMPAT,EPP,ECP] > [ 8.620688] lp0: using parport0 (interrupt-driven). > The above shows the board is at least EPP-capablem this is better than before. > Do you test the USC boards before you send them out? If so the board should > be fine. I have not applied any power to it other than the 9v wall wart and > that has only been wired up correctly. > Yes, of course I test them, with an older Siig PCI board, in fact.
Jon ------------------------------------------------------------------------------ Live Security Virtual Conference Exclusive live event will cover all the ways today's security and threat landscape has changed and how IT managers can respond. Discussions will include endpoint security, mobile security and the latest in malware threats. http://www.accelacomm.com/jaw/sfrnl04242012/114/50122263/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
