On 14 December 2012 00:21, andy pugh <[email protected]> wrote: > It is rather a tight fit under the table, between the ways.
https://picasaweb.google.com/lh/photo/7PPw4pWFfZy_jHDMq_KbmdMTjNZETYmyPJy0liipFm0?feat=directlink The servo is slightly fatter than the gap under the square slide, or it would be closer in and pointing the other way for a shorter (and better) belt run. Ball nut OD is 40mm and the flange is 61mm. The gap under the bed is 77.6mm. The main problem is the availability of suitable bearings in suitable sizes. Despite appearances, this isn't a lot more complex than a spinning-screw, as I would still need a motor mount and a ballscrew mount, suitable bearings, and their clamping arrangements. -- atp If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ LogMeIn Rescue: Anywhere, Anytime Remote support for IT. Free Trial Remotely access PCs and mobile devices and provide instant support Improve your efficiency, and focus on delivering more value-add services Discover what IT Professionals Know. Rescue delivers http://p.sf.net/sfu/logmein_12329d2d _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
