Thank for the info. I made the SD image as described. Then i tried to flash the board. I switched the power off, plugged in the sd card and switched the power on while holding the boot button. All four user leds lit for a second or so and than the led 3 and 5 lit solid. I thought now i have to wait for 45 minutes, but nothing happened. Later i tried the board but it still runs with the default software. Any idea what could be wrong?
A also tried to start the board with the sd card inserted and i noticed that the sd card was rewritten with some default beagle board documentation. Regards Klemen ________________________________ From: Charles Steinkuehler <[email protected]> To: Klemen Dovrtel <[email protected]>; Enhanced Machine Controller (EMC) <[email protected]> Sent: Tuesday, July 9, 2013 12:40 PM Subject: Re: [Emc-users] Beaglebone LinuxCNC starterkit -> Beaglebone Black On 7/9/2013 3:40 AM, Klemen Dovrtel wrote: > Hello everybody, > > I noticed the BeagleBone version of LinuxCNC and decided to try it, but it > seems i was not paying enough attention - I bought the Beaglebone Black > instead of Beaglebone. > > Is there a simple way to make the Beaglebone LinuxCNC starterkit work on > BeagleBone Black? Can i use the BeagleBone ready to run sd to flash the > BeagleBone Black? That image is dated. You should start with the SD image from here: http://bb-lcnc.blogspot.com/p/machinekit_16.html ...it works fine with the "White" or the Black. -- Charles Steinkuehler [email protected] ------------------------------------------------------------------------------ See everything from the browser to the database with AppDynamics Get end-to-end visibility with application monitoring from AppDynamics Isolate bottlenecks and diagnose root cause in seconds. Start your free trial of AppDynamics Pro today! http://pubads.g.doubleclick.net/gampad/clk?id=48808831&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
