Yep. You could run 64 machines in parallel! I was looking at this a couple of days ago. Very neat board, but not sure if it's right fit for linuxcnc.
On Wed, Jul 24, 2013 at 10:38 AM, Ralph Stirling < [email protected]> wrote: > For those of you always looking for a cooler, better > hardware platform for LinuxCNC, check out: > > http://www.parallella.org/board/ > > This is an Arm board using a Xilinx Zynq FPGA for > processor and logic. It also has 16-core GPU type > device. I don't know how or when real-time support > will be added. I'm still getting in gear with the > Beaglebone Black, so I'm not ready to jump at something > new, but the combination of Arm and FPGA for $99 is > intriguing. > > -- Ralph > > ------------------------------------------------------------------------------ > See everything from the browser to the database with AppDynamics > Get end-to-end visibility with application monitoring from AppDynamics > Isolate bottlenecks and diagnose root cause in seconds. > Start your free trial of AppDynamics Pro today! > http://pubads.g.doubleclick.net/gampad/clk?id=48808831&iu=/4140/ostg.clktrk > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > > ------------------------------------------------------------------------------ See everything from the browser to the database with AppDynamics Get end-to-end visibility with application monitoring from AppDynamics Isolate bottlenecks and diagnose root cause in seconds. Start your free trial of AppDynamics Pro today! http://pubads.g.doubleclick.net/gampad/clk?id=48808831&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
