On 24 July 2013 16:50, Troy Jacobson <[email protected]> wrote: > I was looking at this a couple of days ago. Very neat board, but not sure > if it's right fit for linuxcnc.
If the FPGA can be persuaded to run the Hostmot2 Firmware then it could run two Mesa daughterboards from the GPIO connector. However, I am not sure that the FPGA has anything like enough gates for that. -- atp If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ See everything from the browser to the database with AppDynamics Get end-to-end visibility with application monitoring from AppDynamics Isolate bottlenecks and diagnose root cause in seconds. Start your free trial of AppDynamics Pro today! http://pubads.g.doubleclick.net/gampad/clk?id=48808831&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
