On Fri, May 1, 2015 at 6:07 AM, Gene Heskett <ghesk...@wdtv.com> wrote:
> On Friday 01 May 2015 05:15:24 Mark Wendt wrote: > > On Fri, May 1, 2015 at 12:52 AM, Gene Heskett <ghesk...@wdtv.com> > > wrote: <snippage> > > > > > Now we have to drag out a scope to look at such > > > stuff. It is even better at finding that stuff, but most look at a > > > scope & go "whazzat thing?", and have no clue even when you tell > > > them what its doing. > > > > Get 'em one a these - Ebay #171772965816 > > > > ;-) > > > > Mark > > That one is out of calibtration by now, and uncalibratable because the > input attenuator parts are out of stock. I will never touch a 20 yo Tek > again after my experience trying to get them to warranty the tube that > was clearly defective in a 22xx, 100mhz dual trace when it was new in > 1984. I finally bought a crt and put it in myself. Long since replaced > with a good Hitachi. 30 years later its still in pretty close > calibration. > > Getting scope poor around here though, I bought a DS0-1 a couple years > back, already have a Hitachi V1065, 100 mhz dual trace analog and just > last fall bought a dual trace 100mhz digital. For 1 shot storage, its > amazing. > > Cheers, Gene Heskett > Never say never. I own a set of them there input attenuators, as well as almost all the gear required to calibration most Tek analog scopes, up to, and including the 7104 1 GHz mainframe. And there are quite a few shops out there that will cal the scopes with certs if you require them too. ------------------------------------------------------------------------------ One dashboard for servers and applications across Physical-Virtual-Cloud Widest out-of-the-box monitoring support with 50+ applications Performance metrics, stats and reports that give you Actionable Insights Deep dive visibility with transaction tracing using APM Insight. http://ad.doubleclick.net/ddm/clk/290420510;117567292;y _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
